Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Will this Work?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Lefty7mmstw" data-source="post: 917017" data-attributes="member: 48043"><p>I'd look at necking down the 338rum before I'd try to push 300 rum brass down .2 inch. That's a lot for rather strong brass; you'd likely have wrinkling and cracking at the neck even with a good anneal job. I'm thinking sort of a reverse 338 edge here. Collet 338 rum dies could be used with a 30cal collet. I believe the 338rum reamer could be used too set up correctly of course.</p></blockquote><p></p>
[QUOTE="Lefty7mmstw, post: 917017, member: 48043"] I'd look at necking down the 338rum before I'd try to push 300 rum brass down .2 inch. That's a lot for rather strong brass; you'd likely have wrinkling and cracking at the neck even with a good anneal job. I'm thinking sort of a reverse 338 edge here. Collet 338 rum dies could be used with a 30cal collet. I believe the 338rum reamer could be used too set up correctly of course. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Will this Work?
Top