Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is your reloading process from start to bang!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Remmy700" data-source="post: 1656126" data-attributes="member: 36564"><p>New brass is my first steps in the post the second set of steps is for fired brass. But yeah I do a seating depth normally of around .015 off lands and then I do charges and try to get an rough idea of where nodes are concerning velocity. I mean once this brass is fire formed obviously case capacity will change and so with all that intel's (pressure, velocity). I normally don't bother with that super fine tuning until all my brass is truly fire formed and my die is setup to that with a .0015 shoulder bump. Then I will really fine tune seating depth and start loading .1 gr around nodes that I have previously found. Again lot of people do seating depth first and then fine tune powder charge which is another option but I personally have always had better luck with seating depth last!.</p></blockquote><p></p>
[QUOTE="Remmy700, post: 1656126, member: 36564"] New brass is my first steps in the post the second set of steps is for fired brass. But yeah I do a seating depth normally of around .015 off lands and then I do charges and try to get an rough idea of where nodes are concerning velocity. I mean once this brass is fire formed obviously case capacity will change and so with all that intel's (pressure, velocity). I normally don't bother with that super fine tuning until all my brass is truly fire formed and my die is setup to that with a .0015 shoulder bump. Then I will really fine tune seating depth and start loading .1 gr around nodes that I have previously found. Again lot of people do seating depth first and then fine tune powder charge which is another option but I personally have always had better luck with seating depth last!. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is your reloading process from start to bang!
Top