Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is the total cost of equipment to start neck turning?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Sending156s" data-source="post: 2587369" data-attributes="member: 109060"><p>So far I've only looked at K&M and the 21st century. This will be for a 25 Creedmoor. The reason will be for a tight chamber. It's on the line where with if everything is just right you don't need to turn. I'm breaking in barrels, & may not have done a perfect job on drying the bore. There was heavy bolt lift. Load light at 41.0 grains H4350 for break in.</p><p>I'll be calling K$M & 21st century asap. These days not always easy to get through to businesses. While waiting I would appreciate your cost estimates for the various equipment, your opinion on ease of use, and the consistency of results. Thanks to all for reading and sharing advice/experiences.</p><p>Reamer print bore neck diameter = .290</p><p>Fired brass neck OD = .28885 - .289</p><p>Virgin brass loaded neck OD = .286</p><p>This is Peterson brass head stamped 25 CM.</p><p>New neck wall as measured = .0125 - .0135</p><p></p><p>All measurements with Mitutoyo tools, Peterson brass, & 135's. Barrels are the Bartleins with the harder steel. 1 SS & 1 CF. Both M24 w/ 8-7.4 RH twist.</p></blockquote><p></p>
[QUOTE="Sending156s, post: 2587369, member: 109060"] So far I’ve only looked at K&M and the 21st century. This will be for a 25 Creedmoor. The reason will be for a tight chamber. It’s on the line where with if everything is just right you don’t need to turn. I’m breaking in barrels, & may not have done a perfect job on drying the bore. There was heavy bolt lift. Load light at 41.0 grains H4350 for break in. I’ll be calling K$M & 21st century asap. These days not always easy to get through to businesses. While waiting I would appreciate your cost estimates for the various equipment, your opinion on ease of use, and the consistency of results. Thanks to all for reading and sharing advice/experiences. Reamer print bore neck diameter = .290 Fired brass neck OD = .28885 - .289 Virgin brass loaded neck OD = .286 This is Peterson brass head stamped 25 CM. New neck wall as measured = .0125 - .0135 All measurements with Mitutoyo tools, Peterson brass, & 135’s. Barrels are the Bartleins with the harder steel. 1 SS & 1 CF. Both M24 w/ 8-7.4 RH twist. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is the total cost of equipment to start neck turning?
Top