Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is a good set up for case trimming & neck turning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Reloader222" data-source="post: 506131" data-attributes="member: 25295"><p>Jinx, I am also using the Foster Original Case Trimmer - it is an excellent choice. At the bottom of the main bearings there is two settings for the bearing screws. For .270 you should fit the bearings at the outmost position. This will give +-1-2 cm clearence from the cutter unit to the case mounth.</p></blockquote><p></p>
[QUOTE="Reloader222, post: 506131, member: 25295"] Jinx, I am also using the Foster Original Case Trimmer - it is an excellent choice. At the bottom of the main bearings there is two settings for the bearing screws. For .270 you should fit the bearings at the outmost position. This will give +-1-2 cm clearence from the cutter unit to the case mounth. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What is a good set up for case trimming & neck turning
Top