Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Weatherby 338-378 grouping issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="valin" data-source="post: 427619" data-attributes="member: 23991"><p>I really do appreciate the input guys. I went back out shooting today, with a buddy of mine who runs the same rifle. I swapped out scopes, and ended up with the same result......still all over the place. We then fired my loads in his 338-378 and ended up with the same results, so therefore, the issue is in the loads. We also fired some 200gr. nosler accubonds on 104 gr. of IMR 7828, and the results were substantially better, but still not great by any means.</p><p></p><p>I have been doing some more research on this site on load data for my rifle, and am going to take all of your advice, and step up into a heavier bullet. I am going to order some Barnes Tipped TSX 225's. I would really appreciate it if you could recommend me some loads for these bullets. Is the IMR 7828 a good powder for this, or should I be switching?</p><p></p><p>I will be using Federal 215 matched primers.</p></blockquote><p></p>
[QUOTE="valin, post: 427619, member: 23991"] I really do appreciate the input guys. I went back out shooting today, with a buddy of mine who runs the same rifle. I swapped out scopes, and ended up with the same result......still all over the place. We then fired my loads in his 338-378 and ended up with the same results, so therefore, the issue is in the loads. We also fired some 200gr. nosler accubonds on 104 gr. of IMR 7828, and the results were substantially better, but still not great by any means. I have been doing some more research on this site on load data for my rifle, and am going to take all of your advice, and step up into a heavier bullet. I am going to order some Barnes Tipped TSX 225's. I would really appreciate it if you could recommend me some loads for these bullets. Is the IMR 7828 a good powder for this, or should I be switching? I will be using Federal 215 matched primers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Weatherby 338-378 grouping issues
Top