Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Vortex Viper 6.5-20x50 & 300 WM problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Broz" data-source="post: 627371" data-attributes="member: 7503"><p>I agree but remember the difference will double if moving a short ring from the rear to the front. So a .007" difference could have the affect of .014". Also this will be affected by ring height too. All that said I think it is time to pull the scope and get a good straight edge on top of the rail. If the rail to receiver top does not match up the problem could have neen induced while tightening the two surfaces to each other.</p><p> </p><p>Jeff</p></blockquote><p></p>
[QUOTE="Broz, post: 627371, member: 7503"] I agree but remember the difference will double if moving a short ring from the rear to the front. So a .007" difference could have the affect of .014". Also this will be affected by ring height too. All that said I think it is time to pull the scope and get a good straight edge on top of the rail. If the rail to receiver top does not match up the problem could have neen induced while tightening the two surfaces to each other. Jeff [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Vortex Viper 6.5-20x50 & 300 WM problem
Top