Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To neck turn, to ream or not to ream?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JSHKS" data-source="post: 1547480" data-attributes="member: 103581"><p>I found little if any use on turning for a factory or a chamber that did not need to be thinned. The neck acts as a bushing of sorts for the bullet. To thick or to thin is not well received. </p><p>When turned properly the donut will roll to the outside and be turned off. </p><p>A shave of sorts just to knock off high spots may or may not gain anything. </p><p>It does t bother me to turn necks, IF it gives me some type of gain, it is a one time thing. Where as I hate trimming.</p></blockquote><p></p>
[QUOTE="JSHKS, post: 1547480, member: 103581"] I found little if any use on turning for a factory or a chamber that did not need to be thinned. The neck acts as a bushing of sorts for the bullet. To thick or to thin is not well received. When turned properly the donut will roll to the outside and be turned off. A shave of sorts just to knock off high spots may or may not gain anything. It does t bother me to turn necks, IF it gives me some type of gain, it is a one time thing. Where as I hate trimming. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To neck turn, to ream or not to ream?
Top