Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To inside ream or neck turn
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rickjoty" data-source="post: 1617059" data-attributes="member: 99582"><p>I also purchased the expanding mandrel with the cutter end. Indeed it does leave a bit of a swirl look to the inside of the necks. I figure that it is even all the way around. Plus, I mostly do it only once as I turn the necks at the same time. On some brass I have checked the necks after another firing or two. I usually get a little more trim here and there off the outside of the necks. I really don't know anything about welding issues.</p></blockquote><p></p>
[QUOTE="rickjoty, post: 1617059, member: 99582"] I also purchased the expanding mandrel with the cutter end. Indeed it does leave a bit of a swirl look to the inside of the necks. I figure that it is even all the way around. Plus, I mostly do it only once as I turn the necks at the same time. On some brass I have checked the necks after another firing or two. I usually get a little more trim here and there off the outside of the necks. I really don't know anything about welding issues. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To inside ream or neck turn
Top