Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
throating 7mmRemMag for 180 eld-m
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AKSavage" data-source="post: 1383962" data-attributes="member: 95938"><p>Well, that's the problem right there. I would be asking the barrel manufacturer to throat it out for me. So given that I assume you would prefer to spend the extra for a (semi-)custom reamer? It occurs to me that I could then also specify a (slightly) longer neck to allow my brass to grow a bit before trimming. Hmmm. Thoughts on that?</p><p></p><p>As far as the throat length, that's where I'd have to study more reamer prints. I got that .095" from another post, but it was a bit vague. I'm good at math but don't know enough about reamers to take my OAL measurement and translate it into a throat length. To complicate matters, I have two different 7mm inserts for measuring base to ogive length, one from Hornady and one from Sinclair, and they give different lengths, so it's hard to know which to trust.</p></blockquote><p></p>
[QUOTE="AKSavage, post: 1383962, member: 95938"] Well, that's the problem right there. I would be asking the barrel manufacturer to throat it out for me. So given that I assume you would prefer to spend the extra for a (semi-)custom reamer? It occurs to me that I could then also specify a (slightly) longer neck to allow my brass to grow a bit before trimming. Hmmm. Thoughts on that? As far as the throat length, that's where I'd have to study more reamer prints. I got that .095" from another post, but it was a bit vague. I'm good at math but don't know enough about reamers to take my OAL measurement and translate it into a throat length. To complicate matters, I have two different 7mm inserts for measuring base to ogive length, one from Hornady and one from Sinclair, and they give different lengths, so it's hard to know which to trust. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
throating 7mmRemMag for 180 eld-m
Top