Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Temperature and POI Change…?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Full Curl" data-source="post: 2015033" data-attributes="member: 47602"><p>I never experienced cold welding before and don't know much about it. All rounds were loaded 2-3 years ago with 3 times fired brass and nosler bullets. Brass was wet cleaned with SS media and shoulder bumped a few thousandths. I use imperial case lube and a little might get in the case mouth which helps the expander ball. Maybe a very small amount is still in there when I seat the bullet?? Ammo is stored in my basement which is low humidity and temp controlled. None of my other calibers have experienced this??</p></blockquote><p></p>
[QUOTE="Full Curl, post: 2015033, member: 47602"] I never experienced cold welding before and don't know much about it. All rounds were loaded 2-3 years ago with 3 times fired brass and nosler bullets. Brass was wet cleaned with SS media and shoulder bumped a few thousandths. I use imperial case lube and a little might get in the case mouth which helps the expander ball. Maybe a very small amount is still in there when I seat the bullet?? Ammo is stored in my basement which is low humidity and temp controlled. None of my other calibers have experienced this?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Temperature and POI Change…?
Top