Stoney Point Target Knobs

Discussion in 'Long Range Scopes and Other Optics' started by Captn C, Dec 28, 2007.

  1. Captn C

    Captn C Well-Known Member

    Nov 27, 2007
    Are these thing worth spend a few dollars on until a person could buy a scope with them made on it?

    Anyone ever use them on a Tasco with target knobs? I assume they go on the outside of the exsiting knob?!?!?!????????
  2. auquhollie

    auquhollie Member

    Dec 29, 2007
    IMHO there are crap. Stay away from them, just wait untill you have the funds to buy a better scope with the turrets attached. Years ago i did buy a set and they never returned to the original zero. Waste of your money.


  3. jmden

    jmden Well-Known Member

    Nov 2, 2003
    I've used a set for several years on my Vari-X III 4.5-14 and they've worked very well for clicking to out past 1K. On this scope, the marks on the turrets are 1/4 MOA and the numbers are 1 MOA, so they work perfectly to match the clicks on the scope. They aren't made any more, but if you can find them and they fit your scope as above, they seem to be a cheaper alternative. Mine were not designed to go outside of an existing target knob, but screw onto where the cap would've screwed on to cover the vertical or horizontal adjustment of the scope. What's wrong with the current turrets you have? Good luck.