Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Stock inlet question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Petersen" data-source="post: 1565193" data-attributes="member: 8372"><p>Stock screw spaced Remington long action. Bottom is milled out a little different. No stock material in front of trigger area and rear of mag box area a little wider and that area goes most of the way up. BDL floorplate will fit with small gaps on sides. Kwik Klip is too tight but could be opened up for it. It was definitely cut for something specific, trying to figure</p><p>Out. Any ideas appreciated. Thanks</p></blockquote><p></p>
[QUOTE="Petersen, post: 1565193, member: 8372"] Stock screw spaced Remington long action. Bottom is milled out a little different. No stock material in front of trigger area and rear of mag box area a little wider and that area goes most of the way up. BDL floorplate will fit with small gaps on sides. Kwik Klip is too tight but could be opened up for it. It was definitely cut for something specific, trying to figure Out. Any ideas appreciated. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Stock inlet question
Top