Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="boomtube" data-source="post: 491820" data-attributes="member: 9215"><p>"...the decapping pin is not spinning perfectly in the center of the die body. Is that normal?"</p><p> </p><p>It isn't 'right' but it is pretty well normal. </p><p> </p><p>Would be nice if the spindle holder was perfect but the ill effects are usually much less than some folks believe. Fact is, the decap/expander rod isn't sufficently rigid to cause the necks to be pulled out of line very badly but the look does irritate us. On those few spindles that are significantly our of alignment I tend to leave the lock rings on the things a bit loose so they can wiggle/float into better alignment.</p></blockquote><p></p>
[QUOTE="boomtube, post: 491820, member: 9215"] "...the decapping pin is not spinning perfectly in the center of the die body. Is that normal?" It isn't 'right' but it is pretty well normal. Would be nice if the spindle holder was perfect but the ill effects are usually much less than some folks believe. Fact is, the decap/expander rod isn't sufficently rigid to cause the necks to be pulled out of line very badly but the look does irritate us. On those few spindles that are significantly our of alignment I tend to leave the lock rings on the things a bit loose so they can wiggle/float into better alignment. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
Top