Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BigSkyGP" data-source="post: 491726" data-attributes="member: 28118"><p>There should be instructions with your dies for adjusting this. I've tried a couple different ways. Using the brass to center the stem, and holding the stem while tightening the lock nut, snug enough to not come lose, but not so tight I can't get the nut lose to adjust it again later if needed.</p></blockquote><p></p>
[QUOTE="BigSkyGP, post: 491726, member: 28118"] There should be instructions with your dies for adjusting this. I've tried a couple different ways. Using the brass to center the stem, and holding the stem while tightening the lock nut, snug enough to not come lose, but not so tight I can't get the nut lose to adjust it again later if needed. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
Top