Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="johnnyk" data-source="post: 491690" data-attributes="member: 307"><p>CRNA,</p><p>When I notice that with my dies, I start the case up into the die just enough to make sure the neck of the case is around the expander, stop the ram and unloose the spindle lock on top and then retighten it. This will help center it unless it's machined off center or spindle rod is bent. Most die mfg's will send replacement parts free of charge. JohnnyK.</p></blockquote><p></p>
[QUOTE="johnnyk, post: 491690, member: 307"] CRNA, When I notice that with my dies, I start the case up into the die just enough to make sure the neck of the case is around the expander, stop the ram and unloose the spindle lock on top and then retighten it. This will help center it unless it's machined off center or spindle rod is bent. Most die mfg's will send replacement parts free of charge. JohnnyK. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Spindle and decapping pin out of line?
Top