Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Single point threading in reverse
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1625955" data-attributes="member: 2736"><p>When you run the tool upside down, it tends to lift the carriage and can cause the tool to rise and grab, sometimes breaking it. if you thread on the inside and start on the close side, it applies down force to the lathe carriage and produces normal loads on the lathe tool and carriage.</p><p></p><p>The main difference is that the cross feed and compound work differently (Backwards) than outside thread cutting and can get confusing sometimes.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1625955, member: 2736"] When you run the tool upside down, it tends to lift the carriage and can cause the tool to rise and grab, sometimes breaking it. if you thread on the inside and start on the close side, it applies down force to the lathe carriage and produces normal loads on the lathe tool and carriage. The main difference is that the cross feed and compound work differently (Backwards) than outside thread cutting and can get confusing sometimes. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Single point threading in reverse
Top