Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair NT-4000 Neck Turning?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jeffwhip" data-source="post: 537644" data-attributes="member: 22355"><p>SBruce,</p><p></p><p>I do have a tight-necked chamber. I've thought about turning them all down to .012 but was afraid to take that much off. It makes sense that if my cutter is set to .0125 that it would skip over any portion that is less than that.</p><p></p><p>So, for now I thought what I would do is measure my trimmed cases and separate any case that is less than .0125. After I find a load, I'll load some up in these cases and see if there is a difference in accuracy.</p><p></p><p>What say ye?</p></blockquote><p></p>
[QUOTE="jeffwhip, post: 537644, member: 22355"] SBruce, I do have a tight-necked chamber. I've thought about turning them all down to .012 but was afraid to take that much off. It makes sense that if my cutter is set to .0125 that it would skip over any portion that is less than that. So, for now I thought what I would do is measure my trimmed cases and separate any case that is less than .0125. After I find a load, I'll load some up in these cases and see if there is a difference in accuracy. What say ye? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair NT-4000 Neck Turning?
Top