Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair NT-4000 Neck Turning?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jeffwhip" data-source="post: 537332" data-attributes="member: 22355"><p>This is my "first rodeo" at neck turning. I just got done turning some necks on my 280 AI Nosler brass over the weekend. The question I have is that most of the brass came out very uniform. The measurement middle-way up the neck is .0125, but when I take a measurement just below the neck, my measurement is .0130.</p><p></p><p>1. So my question for you guys, does this .0005 disparity really matter? Or is this close enough for govt work?</p><p></p><p>2. I do have some brass that are measuring .0120 on one side and .0125 on the other because I have my cutter set at .0125. Is that good enough?</p><p></p><p>3. Do any of you cull the brass if there is a certain disparity in the neck thickness or do you organize your brass according to overall weight?</p><p></p><p>4. What criteria should I use to cull brass?</p><p></p><p>Thanks in advance!</p></blockquote><p></p>
[QUOTE="jeffwhip, post: 537332, member: 22355"] This is my "first rodeo" at neck turning. I just got done turning some necks on my 280 AI Nosler brass over the weekend. The question I have is that most of the brass came out very uniform. The measurement middle-way up the neck is .0125, but when I take a measurement just below the neck, my measurement is .0130. 1. So my question for you guys, does this .0005 disparity really matter? Or is this close enough for govt work? 2. I do have some brass that are measuring .0120 on one side and .0125 on the other because I have my cutter set at .0125. Is that good enough? 3. Do any of you cull the brass if there is a certain disparity in the neck thickness or do you organize your brass according to overall weight? 4. What criteria should I use to cull brass? Thanks in advance! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair NT-4000 Neck Turning?
Top