Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump problem? Not far enough?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Broz" data-source="post: 867143" data-attributes="member: 7503"><p>Yes, they are the opposite. they limit the amount of case going into the die because most dies do too much. But if your .006" is correct, and you took .010" off the bottom of the die, the comp shell holders would put you right in the middle and allow you to adjust the shoulder head space in either direction. </p><p> </p><p>You must have a short chambered rifle, long die or tall shell holder. Most likely a long die. I have only ground off a couple dies in 30+ years of reloading. </p><p> </p><p>Jeff</p></blockquote><p></p>
[QUOTE="Broz, post: 867143, member: 7503"] Yes, they are the opposite. they limit the amount of case going into the die because most dies do too much. But if your .006" is correct, and you took .010" off the bottom of the die, the comp shell holders would put you right in the middle and allow you to adjust the shoulder head space in either direction. You must have a short chambered rifle, long die or tall shell holder. Most likely a long die. I have only ground off a couple dies in 30+ years of reloading. Jeff [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump problem? Not far enough?
Top