Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump problem? Not far enough?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BillyGoatGruff" data-source="post: 866670" data-attributes="member: 63346"><p>Broz</p><p></p><p>I tried Sully2's idea of a shim. I took a case that was sized and measured .126"</p><p>I then slipped a .010"standard feeler blade gauge beneath the case and ran it through again.</p><p>Low and behold it worked! I got .116"! THANKS Sully2!</p><p>So I think these shell holders you describe will work. If I read this correct? they will step UP INTO the die in .002" increments from a standard shell holder?</p><p></p><p>Thanks guys for throwing ideas at me and helping me find a solution to the problem. This has been driving me crazy for two weeks now.</p><p></p><p>This might be slightly off topic.</p><p>I have all this brass. Federal was the worst followed by Hornady then Winchester</p><p>as far as finding cases that would fit. The cases that I had the best luck with was some nickel coated Winchester. What is the purpose of the nickel coating and is this type brass any good?</p><p></p><p>What are the general opinions on brass? What's best?</p><p></p><p>Thanks again, BGG</p></blockquote><p></p>
[QUOTE="BillyGoatGruff, post: 866670, member: 63346"] Broz I tried Sully2's idea of a shim. I took a case that was sized and measured .126" I then slipped a .010"standard feeler blade gauge beneath the case and ran it through again. Low and behold it worked! I got .116"! THANKS Sully2! So I think these shell holders you describe will work. If I read this correct? they will step UP INTO the die in .002" increments from a standard shell holder? Thanks guys for throwing ideas at me and helping me find a solution to the problem. This has been driving me crazy for two weeks now. This might be slightly off topic. I have all this brass. Federal was the worst followed by Hornady then Winchester as far as finding cases that would fit. The cases that I had the best luck with was some nickel coated Winchester. What is the purpose of the nickel coating and is this type brass any good? What are the general opinions on brass? What's best? Thanks again, BGG [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump problem? Not far enough?
Top