Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump FL sizing and measurements
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MNbogboy" data-source="post: 1852011" data-attributes="member: 18849"><p>Agree 2 to 3 firings to reach full length then I anneal and bump every cycle. I also measure each case before & after bumping. Some cases often are a little different than the others and I make slight die adjustments to compensate. Ideally my goal is .0015 to .0025 bump. </p><p></p><p>Lots of good advice on this thread.</p></blockquote><p></p>
[QUOTE="MNbogboy, post: 1852011, member: 18849"] Agree 2 to 3 firings to reach full length then I anneal and bump every cycle. I also measure each case before & after bumping. Some cases often are a little different than the others and I make slight die adjustments to compensate. Ideally my goal is .0015 to .0025 bump. Lots of good advice on this thread. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bump FL sizing and measurements
Top