Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Setting up a Full Length die.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="woods" data-source="post: 303191" data-attributes="member: 6042"><p>Here's a question but first let me set it up. As discussed when you set your die so that it has started resizing the case body, it starts pushing the shoulder forward. On once fired cases the shoulder is typically a few thousandths away from contacting the chamber shoulder. </p><p></p><p>Question</p><p></p><p>In your experience, when sizing once fired brass, is it possible to push the case shoulder far enough forward to contact the chamber shoulder?</p><p></p><p>Last time I checked, I was only able to push the shoulder .001" or so on once fired cases and that was not enough to enable the body die to contact the shoulder and place it exactly where I wanted it. Is there any other way to accelerate the brass expansion sequence so that you can size for a slight crush fit on once fired cases?</p></blockquote><p></p>
[QUOTE="woods, post: 303191, member: 6042"] Here's a question but first let me set it up. As discussed when you set your die so that it has started resizing the case body, it starts pushing the shoulder forward. On once fired cases the shoulder is typically a few thousandths away from contacting the chamber shoulder. Question In your experience, when sizing once fired brass, is it possible to push the case shoulder far enough forward to contact the chamber shoulder? Last time I checked, I was only able to push the shoulder .001" or so on once fired cases and that was not enough to enable the body die to contact the shoulder and place it exactly where I wanted it. Is there any other way to accelerate the brass expansion sequence so that you can size for a slight crush fit on once fired cases? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Setting up a Full Length die.
Top