Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
RWS Cases
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="srlamy" data-source="post: 603356" data-attributes="member: 36880"><p>I picked up some 300 wm rws from huntingtons. I use lapua in my 308 but we all no its no longer around for 300 wm.. I loaded some 175smk's to break in the barrel. 3 manuels gave me a low charge of 77 grains of h1000 and a high of 79.5. I loaded 78 grains and it was almost a compressed load. this brass is thick thick.. The first shot showed a really flat primer. after the rub and scrub to break in properly the second shot didn't have the flat primer. The speed was 3000 fps from my ohler. BTW the barrel was cryo dipped before the build. after the third round I had no copper fouling and 3 scrubs with butches cleaned it up. I ran sweets through it and let it sit for a bit.... no copper residue. I hope the barrel will polish with a little more time 3000 fps seems slow to me. make sure you start low on the powder!</p></blockquote><p></p>
[QUOTE="srlamy, post: 603356, member: 36880"] I picked up some 300 wm rws from huntingtons. I use lapua in my 308 but we all no its no longer around for 300 wm.. I loaded some 175smk's to break in the barrel. 3 manuels gave me a low charge of 77 grains of h1000 and a high of 79.5. I loaded 78 grains and it was almost a compressed load. this brass is thick thick.. The first shot showed a really flat primer. after the rub and scrub to break in properly the second shot didn't have the flat primer. The speed was 3000 fps from my ohler. BTW the barrel was cryo dipped before the build. after the third round I had no copper fouling and 3 scrubs with butches cleaned it up. I ran sweets through it and let it sit for a bit.... no copper residue. I hope the barrel will polish with a little more time 3000 fps seems slow to me. make sure you start low on the powder! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
RWS Cases
Top