Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Rough chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="shortgrass" data-source="post: 2506881" data-attributes="member: 24284"><p>Repeatedly, we see posts like this one showing scarred-up brass from a 'new' chamber (sometimes factory, sometimes custom cut). There are some "Doozies" about, as this would never occur if the newly chambered barrel was 'test fired' ,and the fired brass examined, before sending it out the door! Some must not care if they've done a good job or not. Or, they are so overly confident they neglect to double check their work. I see it as only prudent to fire a couple, measure the case heads and give it a close "look-see".</p></blockquote><p></p>
[QUOTE="shortgrass, post: 2506881, member: 24284"] Repeatedly, we see posts like this one showing scarred-up brass from a 'new' chamber (sometimes factory, sometimes custom cut). There are some "Doozies" about, as this would never occur if the newly chambered barrel was 'test fired' ,and the fired brass examined, before sending it out the door! Some must not care if they've done a good job or not. Or, they are so overly confident they neglect to double check their work. I see it as only prudent to fire a couple, measure the case heads and give it a close "look-see". [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Rough chamber?
Top