Rock River Arms Elite Operator 2?

Discussion in 'AR15/10 Rifles' started by jeffwhip, Aug 14, 2011.

  1. jeffwhip

    jeffwhip Well-Known Member

    Messages:
    107
    Joined:
    Dec 31, 2009
    I just bought a Rock River Arms Elite Operator 2 and am getting ready to reload for it. My question for anyone out there, is how far can I seat the bullet and still get it to feed properly? I suspect if I try to seat the bullet close to the lands it will not feed properly.

    Any input will be greatly appreciated.
     
  2. Doe

    Doe Member

    Messages:
    18
    Joined:
    Feb 16, 2011
    All though most rifle like it when you seat the bullet cloest to the land, but then some will not?? go..figure :cool: your going to have to play with seating depth and see what you rifle likes. With a box mag your limited to mag length unless you are going to load it one at a time :D. I know not much help, but Good Luck!!
     

  3. SLOAN

    SLOAN Well-Known Member

    Messages:
    128
    Joined:
    Mar 8, 2011
    Load to mag lenght an adjust from there.Sloan.....gun)
     
  4. kc0pph

    kc0pph Well-Known Member

    Messages:
    371
    Joined:
    Aug 6, 2011
    I had a DPMS AR-15 with a 13" barrel and a 3" Novske Pig Welded on to it. My AR did not much care what bullet length i used as long as it fit in the mag. But what it did care about was the sizing. Full Length is not really full lenghth. Get a small base sizer and that will fix the issues. (Or in mine it did).