Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Resizing 7mmRUM to 338RUM Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="royinidaho" data-source="post: 119793" data-attributes="member: 2011"><p>Got a deal on bunch of new &amp; once fired 7mm RUM cases, REM of course.....</p><p></p><p>Figured that some of these could be resized to 338 RUM. So I gave it a go on one case.</p><p></p><p>Wasn't much of a problem running the case through the 338 RUM FL Sizer. Pushing the shoulder back that tenth inch or so took a little bit of umph....</p><p></p><p>The problem was wrinkes in the form of dents in the shoulder. Not from lube but from more brass going into less area.....</p><p></p><p>Fired the case, the dents got much smaller but are still there.</p><p></p><p>Was this whole thing another of my dumb ideas to save a couple of cents??</p><p></p><p>Suggestions? or just don't do it?</p></blockquote><p></p>
[QUOTE="royinidaho, post: 119793, member: 2011"] Got a deal on bunch of new & once fired 7mm RUM cases, REM of course..... Figured that some of these could be resized to 338 RUM. So I gave it a go on one case. Wasn't much of a problem running the case through the 338 RUM FL Sizer. Pushing the shoulder back that tenth inch or so took a little bit of umph.... The problem was wrinkes in the form of dents in the shoulder. Not from lube but from more brass going into less area..... Fired the case, the dents got much smaller but are still there. Was this whole thing another of my dumb ideas to save a couple of cents?? Suggestions? or just don't do it? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Resizing 7mmRUM to 338RUM Question
Top