repacement stock for 15i

Discussion in 'PSE TAC 15/15i Crossbow Hunting Forum' started by Luv2turn, Oct 22, 2011.

  1. Luv2turn

    Luv2turn Member

    Messages:
    24
    Joined:
    Sep 20, 2011
    Can anyone recommend a replacement stock or add on for the stock?

    I do not get a comfortable spot weld with the stock item.

    Mike
     
  2. Thegunt

    Thegunt Member

    Messages:
    7
    Joined:
    Aug 21, 2011
    I replaced mine with a MagPul CTR with the commercial diameter tube.
    It eliminates all the slop or play that was found with the stock unit.
    This setup works well for me.
     

  3. Ranger488

    Ranger488 Member

    Messages:
    7
    Joined:
    Jun 16, 2011
    Does anyone know of a replacement stock that offers greater length? I'm very tall with long arms. The factory stock is at least 3 inches too short for my long arms. Thanks!
     
  4. jon.henry755

    jon.henry755 Well-Known Member

    Messages:
    391
    Joined:
    Dec 16, 2010
    Hi Ranger488,
    Brownell's offers extension buffer tubes that will add 1.5 inches of additional length to your stock and they also offer butt pads that will add another inch to the length.

    Go to World's Largest Supplier of Gun Parts, Gunsmith Tools & Shooting Accessories - Brownells and type in AR15 parts under the category for shop by rifle type. Here you can find anything and everything available for your stock needs. Once you've found what you're searching for you can also do open searches under Google to insure you're getting the best possible prices.

    The extension buffer tube is a very simple change that takes no more than 10 minutes and needs no special tools.

    Jon
     
  5. Ranger488

    Ranger488 Member

    Messages:
    7
    Joined:
    Jun 16, 2011
    Thanks Jon! Do you know if the crossbow will still fit in the PSE TAC softside case with the stock add-ons you recommended? Chuck
     
  6. jon.henry755

    jon.henry755 Well-Known Member

    Messages:
    391
    Joined:
    Dec 16, 2010
    Hi Chuck,
    The quick answer is Yes.

    With the buttstock adjusted inward, the stock is only an inch or so longer than it is now. The case has plenty of room for the length of the crossbow, it was always tight from left to right to handle the width of the front end.

    I think the case will even handle the crossbow with the stock over three quarters extended.

    Regards,

    Jon