Removing the REM700 J-Lock

dwm

Well-Known Member
Joined
Feb 26, 2003
Messages
756
Location
Texas
Here is a way to remove the J-Lock from your Rem700 bolt. (Required to install an HS Precision tactical stock if you have a J-Lock bolt.)

From Sinclair International:

These new complete firing pin assemblies from PIERCEision Gun Works install in Remington 700 bolts in just a few seconds with the Sinclair RFPT Firing Pin Tool. The firing pin assembly replaces the OEM firing pin, mainspring and bolt shroud in both pre-lock and post-lock bolts with the same unit. No firing pin disassembly is required. PIERCEision firing pin assemblies give shooters a faster lock time of 2.3 milliseconds and increase firing pin energy to 4.3 inch pounds. You will also get rid of the convoluted firing pin spring in the post lock bolts. Assemblies are available in black or silver for long and short actions. Not available for Model 7, XP or 788 actions.

22-70X.jpg


Package as it came from Sinclair:
image2.jpg


New vs old assembly:

image6.jpg


image5.jpg


New assembly installed on bolt:

image8.jpg


image7.jpg


Not sure if it will help my shooting or not, but when I get ready to buy an HS Precision PST26, it will work ...

BlackTactical2.jpg


Doug

[ 03-31-2004: Message edited by: dwm ]
 
Warning! This thread is more than 20 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top