Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remage contour
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DUSTY NOGGIN" data-source="post: 1479847" data-attributes="member: 89550"><p>the nut will fit, i think you will have a 1-1/2 inch ahead of the nut that normally would be open up to fit that shoulder of a standard remington. i estimate a gap of .095 on each side . then the taper will probably be fairly close after that</p><p></p><p>what stock are you going with</p></blockquote><p></p>
[QUOTE="DUSTY NOGGIN, post: 1479847, member: 89550"] the nut will fit, i think you will have a 1-1/2 inch ahead of the nut that normally would be open up to fit that shoulder of a standard remington. i estimate a gap of .095 on each side . then the taper will probably be fairly close after that what stock are you going with [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remage contour
Top