Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Redding Type S die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="newmexkid" data-source="post: 1095803" data-attributes="member: 33152"><p>Upon reading the instructions on these dies I understand to do the following. Adjust die down until it meets the shell holder. Then adjust stem back 1/16 of a turn so that bushing has a minute amount of give, (slight rattle). I have been sizing only about 1/2 of the neck and adjusting the stem for this, the bushing is very loose in the die. Checking my loaded rounds for concentricity I'm reading .002-.004. Is this about as good as it's going to get?</p></blockquote><p></p>
[QUOTE="newmexkid, post: 1095803, member: 33152"] Upon reading the instructions on these dies I understand to do the following. Adjust die down until it meets the shell holder. Then adjust stem back 1/16 of a turn so that bushing has a minute amount of give, (slight rattle). I have been sizing only about 1/2 of the neck and adjusting the stem for this, the bushing is very loose in the die. Checking my loaded rounds for concentricity I'm reading .002-.004. Is this about as good as it's going to get? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Redding Type S die
Top