Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
QuickLoad file for 30 Sherman Magnum case
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Seabeeken" data-source="post: 2744632" data-attributes="member: 68015"><p>Have you measured every detail? Case length, bullet length, bullet diameter. Did you also check water capacity of a FIRED case? Every single detail is important. Be sure to set the temperature to match the conditions you are shooting in. Garbage in garbage out. Keep in mind that QL and GRT are predictions only. Could you be using powder that is newer or older than the powder model in QL? Once you make absolutely certain that you have every detail correct and accurate, then you can adjust the Ba factor in the powder model until the predicted velocity matches the measured velocity. Then the powder model is adjusted to YOUR rifle. I recommend reading the QL instructions in detail if you havent already done so. There are a number of setting in there you should learn about.</p></blockquote><p></p>
[QUOTE="Seabeeken, post: 2744632, member: 68015"] Have you measured every detail? Case length, bullet length, bullet diameter. Did you also check water capacity of a FIRED case? Every single detail is important. Be sure to set the temperature to match the conditions you are shooting in. Garbage in garbage out. Keep in mind that QL and GRT are predictions only. Could you be using powder that is newer or older than the powder model in QL? Once you make absolutely certain that you have every detail correct and accurate, then you can adjust the Ba factor in the powder model until the predicted velocity matches the measured velocity. Then the powder model is adjusted to YOUR rifle. I recommend reading the QL instructions in detail if you havent already done so. There are a number of setting in there you should learn about. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
QuickLoad file for 30 Sherman Magnum case
Top