Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Question on tenon size after threading...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="44-40" data-source="post: 2849572" data-attributes="member: 126985"><p>Your measurements are wrong. Cause the. 1.0625" hole will fit easily over a 1.060" shaft or tenon. .0025" clearence will easily fit. The orginal barrel as you measured is out of print for a 1.062× 16 thread at 1.050" ot 1.049" OD if that measurement is even correct. </p><p>So if the barrel will thread into your action... without the recoil lug ...thats good. Check for a burr or ding on the recoil lug ID and remove or polish it off.</p><p>All ya got to do is open up the recoil lug hole dia..</p><p>Or easier you, grab or buy another or new recoil lug 1.0625" hole dia ... it will fit.</p></blockquote><p></p>
[QUOTE="44-40, post: 2849572, member: 126985"] Your measurements are wrong. Cause the. 1.0625" hole will fit easily over a 1.060" shaft or tenon. .0025" clearence will easily fit. The orginal barrel as you measured is out of print for a 1.062× 16 thread at 1.050" ot 1.049" OD if that measurement is even correct. So if the barrel will thread into your action... without the recoil lug ...thats good. Check for a burr or ding on the recoil lug ID and remove or polish it off. All ya got to do is open up the recoil lug hole dia.. Or easier you, grab or buy another or new recoil lug 1.0625" hole dia ... it will fit. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Question on tenon size after threading...
Top