Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
PTG Remington 700 Bolt Extractor Issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="johnnymac" data-source="post: 908979" data-attributes="member: 17435"><p>Hey Everyone,</p><p> </p><p>I recently chambered a barrel in 6.5 creedmoor to go on a Remington 700 action I had. I ordered one of PTG's replacement bolts with the mini m16 extractor. I made the counterbore a little oversized at .720 after reading about issues others were having with a standard size counterbore. I'm having trouble extracting a fired case but the problem doesnt seem to be coming from the counterbore. When I try to extract the case it only starts to come out for maybe 1/8 of an inch and then pops out from underneath the extractor. It's almost as if there isnt enough spring tension on the extractor to allow it to snap back over the rim of the case. Any ideas or help would be greatly appreciated.</p><p> </p><p>Thanks,</p><p>John</p></blockquote><p></p>
[QUOTE="johnnymac, post: 908979, member: 17435"] Hey Everyone, I recently chambered a barrel in 6.5 creedmoor to go on a Remington 700 action I had. I ordered one of PTG's replacement bolts with the mini m16 extractor. I made the counterbore a little oversized at .720 after reading about issues others were having with a standard size counterbore. I'm having trouble extracting a fired case but the problem doesnt seem to be coming from the counterbore. When I try to extract the case it only starts to come out for maybe 1/8 of an inch and then pops out from underneath the extractor. It's almost as if there isnt enough spring tension on the extractor to allow it to snap back over the rim of the case. Any ideas or help would be greatly appreciated. Thanks, John [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
PTG Remington 700 Bolt Extractor Issues
Top