Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Problems Resizing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Seabeeken" data-source="post: 2663694" data-attributes="member: 68015"><p>Ive seen this in a few of my dies with the expander ball removed. It usually goes away when i run them over expander mandrel. Saw it also when forming brass for my 250ai. Not certain what causes it. Perhaps annealing will help. You would think it would straighten back out as it is withdrawn out of the die. Maybe springback if the neck is going past the end of the neck sizing area of the die.</p></blockquote><p></p>
[QUOTE="Seabeeken, post: 2663694, member: 68015"] Ive seen this in a few of my dies with the expander ball removed. It usually goes away when i run them over expander mandrel. Saw it also when forming brass for my 250ai. Not certain what causes it. Perhaps annealing will help. You would think it would straighten back out as it is withdrawn out of the die. Maybe springback if the neck is going past the end of the neck sizing area of the die. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Problems Resizing
Top