Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
pressure signs at 1 grain over books starting load
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="shawn338lapua" data-source="post: 840881" data-attributes="member: 70112"><p>ok so let me say i am very new to reloading. I am shooting a savage 111 LRH in the 338 lapua. i started putting some loads together and the book (Modern Reloading, 2nd addition richard lee) says to start at 83 grains. i am using H1000, Lapua brass and lapua scenar 300 gr and cci MLR primers #250. i shot a 3 round group with 84 grains. 1 of the primers flattened and all three show slight ejector circles. is this normal? should i try my load ladder below what the book recommends since i am getting pressure signs early? Also i tried FL resizing some brass that where making my bolt stick(also showed signs of OP), no improvement, any suggestions? i am using a RCBS FL die. am i going to have to shell out for a more expensive die? anyways any help would be great. thanks</p></blockquote><p></p>
[QUOTE="shawn338lapua, post: 840881, member: 70112"] ok so let me say i am very new to reloading. I am shooting a savage 111 LRH in the 338 lapua. i started putting some loads together and the book (Modern Reloading, 2nd addition richard lee) says to start at 83 grains. i am using H1000, Lapua brass and lapua scenar 300 gr and cci MLR primers #250. i shot a 3 round group with 84 grains. 1 of the primers flattened and all three show slight ejector circles. is this normal? should i try my load ladder below what the book recommends since i am getting pressure signs early? Also i tried FL resizing some brass that where making my bolt stick(also showed signs of OP), no improvement, any suggestions? i am using a RCBS FL die. am i going to have to shell out for a more expensive die? anyways any help would be great. thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
pressure signs at 1 grain over books starting load
Top