Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
PPU brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bigedp51" data-source="post: 1730813" data-attributes="member: 28965"><p>The Redding competition shell holders are "NOT" shorter, they are from .002 to .010 "TALLER" and push the case shoulder back "LESS" than a standard shell holder. Meaning they do not push the case as far into the die as a standard shell holder.</p><p></p><p>Most sizing dies when adjusted to make hard contact with the shell holder with press cam over can push the case shoulder back further than needed. This allows the case to fit in any chamber even at minimum headspace. And the Redding competition shell holders allow you to decrease the amount of shoulder bump without touching the die.</p><p></p><p>Bottom line Redding competition shell holders are not the answer to this problem. And lapping the top of the shell holder is the cure to this problem because you do not need a machine shop to lap a cheaper shell holder.</p></blockquote><p></p>
[QUOTE="bigedp51, post: 1730813, member: 28965"] The Redding competition shell holders are "NOT" shorter, they are from .002 to .010 "TALLER" and push the case shoulder back "LESS" than a standard shell holder. Meaning they do not push the case as far into the die as a standard shell holder. Most sizing dies when adjusted to make hard contact with the shell holder with press cam over can push the case shoulder back further than needed. This allows the case to fit in any chamber even at minimum headspace. And the Redding competition shell holders allow you to decrease the amount of shoulder bump without touching the die. Bottom line Redding competition shell holders are not the answer to this problem. And lapping the top of the shell holder is the cure to this problem because you do not need a machine shop to lap a cheaper shell holder. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
PPU brass
Top