Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
PPU 7mag brass sticking
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rsnell" data-source="post: 2051501" data-attributes="member: 84903"><p>I could not chamber brass in my 300 Weatherby magnum if the diameter of the case immediately above the belt was 0.513 inches. I have a collet die sold by Innovative Technologies that will resize the case immediately above the belt. The die is expensive, approximately $120, but it works and will work on a number of different belted cases. I was worth the cost to me since Weatherby brass is about $1.80 a case. After running my brass through the die, it measured 0.509 inches.</p></blockquote><p></p>
[QUOTE="rsnell, post: 2051501, member: 84903"] I could not chamber brass in my 300 Weatherby magnum if the diameter of the case immediately above the belt was 0.513 inches. I have a collet die sold by Innovative Technologies that will resize the case immediately above the belt. The die is expensive, approximately $120, but it works and will work on a number of different belted cases. I was worth the cost to me since Weatherby brass is about $1.80 a case. After running my brass through the die, it measured 0.509 inches. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
PPU 7mag brass sticking
Top