Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Please help me understand chamber dimensions...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="L.Sherm" data-source="post: 1585753" data-attributes="member: 102083"><p>You could very well have a zero freebore reamer that was set up to run the 40-50gr bullets. You need to figure out how much neck clearance you have now, measure a fired case and then a loaded round that will be close to your clearance subtract .001 for spring back. If it's in the neighborhood of .004-.005 you could give some cases a little clean up and test to see if it shoots better. If there much more clearance than .005 I wouldn't worry about it.</p></blockquote><p></p>
[QUOTE="L.Sherm, post: 1585753, member: 102083"] You could very well have a zero freebore reamer that was set up to run the 40-50gr bullets. You need to figure out how much neck clearance you have now, measure a fired case and then a loaded round that will be close to your clearance subtract .001 for spring back. If it's in the neighborhood of .004-.005 you could give some cases a little clean up and test to see if it shoots better. If there much more clearance than .005 I wouldn't worry about it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Please help me understand chamber dimensions...
Top