Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Pillar/skim bedding question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WapitiBob" data-source="post: 607344" data-attributes="member: 38015"><p>To rephrase the question, I have seen the pillars extended above and below the stock mtl so both, the barrel and the btm metal touch only the pillars. I have also seen where only the top of the pillar is extended, which results in the btm metal being tightened up against the stock cut out.</p><p>If the stock is synthetic, does it matter which method is used?</p></blockquote><p></p>
[QUOTE="WapitiBob, post: 607344, member: 38015"] To rephrase the question, I have seen the pillars extended above and below the stock mtl so both, the barrel and the btm metal touch only the pillars. I have also seen where only the top of the pillar is extended, which results in the btm metal being tightened up against the stock cut out. If the stock is synthetic, does it matter which method is used? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Pillar/skim bedding question
Top