Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Optimal neck tension for hunting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Casing" data-source="post: 283286" data-attributes="member: 17014"><p>Kris C,</p><p>I had the same problem when I started reloading years ago. I took care of the problem by switching to Redding dies with a neck bushing which allows you to set the tension to fit your application. The neck bushings are interchangeable to allow you to change the tension. For my hunting ammo I measure a loaded round and subtract .002 and use that size bushing for my brass. That usually allows for the right amount of ''spring back'' when sizing the necks. You can use them in a version of the full length sizing die or a neck die. A good way to check to see if the tension is too loose is to take a finished round and hold the tip of the bullet against your work bench. Push it gently against the bench, if it goes deeper into the case it is too loose. You can also ''learn'' the feel when seating the bullets, if the fit is too loose or too tight. Go to Redding's web site and this is described there also. This cured my problem hope it helps you.</p><p>Casing</p></blockquote><p></p>
[QUOTE="Casing, post: 283286, member: 17014"] Kris C, I had the same problem when I started reloading years ago. I took care of the problem by switching to Redding dies with a neck bushing which allows you to set the tension to fit your application. The neck bushings are interchangeable to allow you to change the tension. For my hunting ammo I measure a loaded round and subtract .002 and use that size bushing for my brass. That usually allows for the right amount of ''spring back'' when sizing the necks. You can use them in a version of the full length sizing die or a neck die. A good way to check to see if the tension is too loose is to take a finished round and hold the tip of the bullet against your work bench. Push it gently against the bench, if it goes deeper into the case it is too loose. You can also ''learn'' the feel when seating the bullets, if the fit is too loose or too tight. Go to Redding's web site and this is described there also. This cured my problem hope it helps you. Casing [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Optimal neck tension for hunting
Top