Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
OCW load development need advice for a newbie
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Frogman77" data-source="post: 306837" data-attributes="member: 15339"><p>hey guys, my once fired brass is hard to chamber occasionally. This is after trimming and full length sizing. If I rotate the brass before chambering sometimes it's easy to close the bolt, and other times it takes a lot of effort. After a while I start to notice brass smearing on the bolt face from just closing the bolt down. After about 10 chamberings of the brass experimenting trying to see what's causing the hard closing bolt the rim of the case head has shiny lines on it almost all the way around it. Anyone ever run into this before?</p></blockquote><p></p>
[QUOTE="Frogman77, post: 306837, member: 15339"] hey guys, my once fired brass is hard to chamber occasionally. This is after trimming and full length sizing. If I rotate the brass before chambering sometimes it's easy to close the bolt, and other times it takes a lot of effort. After a while I start to notice brass smearing on the bolt face from just closing the bolt down. After about 10 chamberings of the brass experimenting trying to see what's causing the hard closing bolt the rim of the case head has shiny lines on it almost all the way around it. Anyone ever run into this before? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
OCW load development need advice for a newbie
Top