nightfource zero stop

Discussion in 'Long Range Scopes and Other Optics' started by qqqq33, May 1, 2009.

  1. qqqq33

    qqqq33 Active Member

    Messages:
    38
    Joined:
    Mar 23, 2009
    ok I give up. It appears that I can not follow directions. Could some one please give me the the moron directions please. Sorry if this was asked aready, did a search but nothing.
     
  2. topwater225

    topwater225 Well-Known Member

    Messages:
    151
    Joined:
    Aug 17, 2006
    Absolutely.....I love the zero stop!!

    While you are setup at the range ready to zero your rifle.......Just take your turret cap off. Loosen the 4 screws on the zero stop clutch (only 1 full turn). Shoot your rifle and set your elevation where you want it (in other words zero your rifle) by turning the middle screw (elevation adjustment). Once you have your rifle zeroed, rotate the zero stop clutch to where the shoulder settles into the clutch stop and snug tighten the 4 screws. Replace your turret cap with the zero on the cap set at the hash mark, and snug tighten the turret cap screws.

    After you do it one time, it will seem very simple. Remember you don't need to loosen any of the screws more than a full turn or so, and don't over tighten.

    Also, remember don't disturb the light grease on the zero stop clutch. It needs to be there.

    I hope that was more clear than mud......:)
     

  3. qqqq33

    qqqq33 Active Member

    Messages:
    38
    Joined:
    Mar 23, 2009
    nf should have hired you to write there directions, done first try thanks