Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice - Bullet Not Seating Properly
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="boogsy" data-source="post: 617085" data-attributes="member: 42306"><p>Don't go get a new die yet! Take the expander pin out of the die and size a case without it then measure the inside of case mouth. Also measure the expander ball. If need be you can emery off .001 or so to leave a tighter grip on the bullet. This ball is hard so it will remove slowly but watch you don't remove to much or you'll be SOL.</p></blockquote><p></p>
[QUOTE="boogsy, post: 617085, member: 42306"] Don't go get a new die yet! Take the expander pin out of the die and size a case without it then measure the inside of case mouth. Also measure the expander ball. If need be you can emery off .001 or so to leave a tighter grip on the bullet. This ball is hard so it will remove slowly but watch you don't remove to much or you'll be SOL. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice - Bullet Not Seating Properly
Top