Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Necking down help.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="260shooter" data-source="post: 1032695" data-attributes="member: 2988"><p>I have a good supply of 1X fired 338 Norma brass, half of which I have necked down to 30 cal for the 300 Norma I have. The problem I have is that right above the neck shoulder junction there is a ring around the bottom of the neck about .010-.020 high. My die is hitting the shellholder now and won't let the die go any lower.</p><p></p><p>Should I take it to my gunsmith and have him take .030-.040 off the shellholder or the bottom of the die? But if the die chamber is too short will this collapse the shoulders?</p><p></p><p>Has anyone else ran into this problem?</p></blockquote><p></p>
[QUOTE="260shooter, post: 1032695, member: 2988"] I have a good supply of 1X fired 338 Norma brass, half of which I have necked down to 30 cal for the 300 Norma I have. The problem I have is that right above the neck shoulder junction there is a ring around the bottom of the neck about .010-.020 high. My die is hitting the shellholder now and won't let the die go any lower. Should I take it to my gunsmith and have him take .030-.040 off the shellholder or the bottom of the die? But if the die chamber is too short will this collapse the shoulders? Has anyone else ran into this problem? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Necking down help.
Top