Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MagnumManiac" data-source="post: 2783853" data-attributes="member: 10755"><p>I never turn to less than .013", even with a sloppy chamber or a 'neck turn only' chamber. I used to turn to .012" in my comp 300WM, it was too thin and caused premature cracking.</p><p>Nowadays, I only turn to clean up the neck, I don't turn to a desired diameter anymore, no need, as long as the brass cleans up for about 80% of it's length, good to go, as I don't size the entire neck either.</p><p></p><p>Cheers.</p></blockquote><p></p>
[QUOTE="MagnumManiac, post: 2783853, member: 10755"] I never turn to less than .013”, even with a sloppy chamber or a ‘neck turn only’ chamber. I used to turn to .012” in my comp 300WM, it was too thin and caused premature cracking. Nowadays, I only turn to clean up the neck, I don’t turn to a desired diameter anymore, no need, as long as the brass cleans up for about 80% of it’s length, good to go, as I don’t size the entire neck either. Cheers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning.
Top