Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning: Trying to turn full neck but seeing cutting high on shoulder (280 AI)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2368507" data-attributes="member: 101791"><p>I agree with ButterBean on where to stop the cut. In setting up my 6mm-280AI. I have found these problem so far. I have found that the ID in the neck area from case to case varies some. So I had the mandrel cut to allow the necks to fit the mandrel. COAL of the case varies some too. The 10 cases I checked varies .0065 from short to long in length. What I have read over the time that case COAL matter too. So I am going to set up and cut the case to length before doing anything else. These cases (500) are brand new and never been fired. I have the equipment to do the work, but didn't have the case until last week. So I have been held up for quite sometime wasn't able to explore and adjust the items I need until now. That alright, because the equipment has taken some time to acquire. Now getting into the finer parts of this operation. I think there will be other mandrels work that will need to be done.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2368507, member: 101791"] I agree with ButterBean on where to stop the cut. In setting up my 6mm-280AI. I have found these problem so far. I have found that the ID in the neck area from case to case varies some. So I had the mandrel cut to allow the necks to fit the mandrel. COAL of the case varies some too. The 10 cases I checked varies .0065 from short to long in length. What I have read over the time that case COAL matter too. So I am going to set up and cut the case to length before doing anything else. These cases (500) are brand new and never been fired. I have the equipment to do the work, but didn't have the case until last week. So I have been held up for quite sometime wasn't able to explore and adjust the items I need until now. That alright, because the equipment has taken some time to acquire. Now getting into the finer parts of this operation. I think there will be other mandrels work that will need to be done. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning: Trying to turn full neck but seeing cutting high on shoulder (280 AI)
Top