Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck turning tool
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Gene" data-source="post: 337189" data-attributes="member: 7402"><p>Kevin is correct; however, after inside reaming you will need to squeeze the outside of the necks down in order to get good tension on the bullet. This step is not necessary if you do not inside ream. I have a full set of inside reamers and have used them in the past, but no longer.</p><p></p><p>Get a good outside neck turning tool, follow the instructions and you will reduce neck thickness and improve concentricity. Also, get a sizer die which accomodates bushings to increase neck tension. Usuallly, a bushing about .002" or .003" less than loaded diameter will suffice.</p></blockquote><p></p>
[QUOTE="Gene, post: 337189, member: 7402"] Kevin is correct; however, after inside reaming you will need to squeeze the outside of the necks down in order to get good tension on the bullet. This step is not necessary if you do not inside ream. I have a full set of inside reamers and have used them in the past, but no longer. Get a good outside neck turning tool, follow the instructions and you will reduce neck thickness and improve concentricity. Also, get a sizer die which accomodates bushings to increase neck tension. Usuallly, a bushing about .002" or .003" less than loaded diameter will suffice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck turning tool
Top