Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning issue
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bill Johnson" data-source="post: 1080078" data-attributes="member: 84129"><p>The "doughnut" forms after you've turned the brass necks down to the neck/shoulder junction and fired the case, unless you radius the edge of the cutting tool a little to cut into the neck/shoulder junction.</p><p> </p><p>I neck turn all the time on fired brass mainly because I buy a lot of once fired, but I've never run into what you're seeing. </p><p> </p><p>I've inside reamed but only on necked down cases where necks were way too thick. I think the "ironing out" process will work. I'd use a good lube like Imperial.</p></blockquote><p></p>
[QUOTE="Bill Johnson, post: 1080078, member: 84129"] The "doughnut" forms after you've turned the brass necks down to the neck/shoulder junction and fired the case, unless you radius the edge of the cutting tool a little to cut into the neck/shoulder junction. I neck turn all the time on fired brass mainly because I buy a lot of once fired, but I've never run into what you're seeing. I've inside reamed but only on necked down cases where necks were way too thick. I think the "ironing out" process will work. I'd use a good lube like Imperial. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning issue
Top