Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning issue
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="toliver" data-source="post: 1079265" data-attributes="member: 74698"><p>I'm in the process of turning some necks on 300 wsm brass that have been fired twice. </p><p>I ran the .308 sizing mandrel through. Then started to turn necks but the mandrel on the turning tool stops at the neck shoulder junction. It will go in with pressure then turn freely, them hard coming out over that spot. Is this the "donut"? If so what's the best remedy? Never had this issue before. Thanks in advance!</p></blockquote><p></p>
[QUOTE="toliver, post: 1079265, member: 74698"] I'm in the process of turning some necks on 300 wsm brass that have been fired twice. I ran the .308 sizing mandrel through. Then started to turn necks but the mandrel on the turning tool stops at the neck shoulder junction. It will go in with pressure then turn freely, them hard coming out over that spot. Is this the "donut"? If so what's the best remedy? Never had this issue before. Thanks in advance! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning issue
Top