Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning and expansion tools
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="nheninge" data-source="post: 275324" data-attributes="member: 13085"><p>If your cutter is not square as in the picture, it will produce a conical neck because the deepest part of the cut is at the back. When you get to the shoulder, it cant cut anymore and you have a case mouth thinner than the brass at the shoulder. This would be very undesirable, replace the cutter. Since you already sent it back, I think you were wise.</p></blockquote><p></p>
[QUOTE="nheninge, post: 275324, member: 13085"] If your cutter is not square as in the picture, it will produce a conical neck because the deepest part of the cut is at the back. When you get to the shoulder, it cant cut anymore and you have a case mouth thinner than the brass at the shoulder. This would be very undesirable, replace the cutter. Since you already sent it back, I think you were wise. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning and expansion tools
Top